Quick3D 3D4Makers PEI Ultem 1000
3D4Makers · PEI filament for FFF
Overview
PEI filament made from Ultem 1000, an amorphous, inherently flame-retardant polyetherimide for continuous use up to 170 °C.
Summarised from the 3D4Makers product page.
Features
- Material type
- High Performance
- Brand family
- 3D4Makers
- Polymer
- PEI
- Processing technology
- FFF
- Material form
- Filament
- Manufacturer
- 3D4Makers
- Reinforcements
- None
Characteristics
- Flame retardantUL 94 rating of V-0, V-1 or V-2 — stops burning on its own once the flame is removed.
Certifications
- UL 94 V-0 (datasheet rating)Flammability rating from the UL 94 test. V-0 is the highest common rating: the flame goes out within 10 seconds with no burning drips.
"Datasheet" means the rating is stated on the manufacturer's datasheet, not a separate certificate. Ask us for the certificate if you need it for an audit.
Applications
Based on this material's datasheet values. Every part is different — ask an engineer to confirm it suits yours.
Physical
- 1.27g/cm³ ISO 1183
- V-0 UL 94
Thermal
- 217°C
Mechanical
- 3200MPa ISO 527
- 105MPa ISO 527
Versus other PEI
See where it ranks against the 15 other PEI materials we stock.
Typical values from each manufacturer's datasheet. Test methods can differ between brands, so treat small gaps as a tie.
Downloads
- Technical data sheet (TDS)pei-ultem-1000-filament Download
- Quick3D summaryThis page as a printable PDF
Values from the 3D4Makers technical data sheet and product page. Last updated . Typical values, not guaranteed minimums — see the disclaimer below.